Electrically Actuated Ball Valves
Manual Ball Valves
Sediment Strainers
Plastic Specialty Valves
Manual Diaphragm Valves
Manual Butterfly Valves
Ball Check Valves / Foot Valves
Compact Molded Ball Valves
Rugged & Compact,
Factory set threaded
seal retainer
provides low running
&
sealing torque,
High in quality, low in cost, Maximum flow with low pressure loss, NSF Approved.
Safe block design,
Fully serviceable.
Internals can be
inspected &
serviced, Reversible
Teflon seats. Doubles the life of the seating
material, Full port design for greater Cv values
Electric actuator,
on/off uni-directional,
150 start/180 stall
inch-lbs of
torque,
NEMA 4, 4x,
reinforced
polypropylene enclosure, position
indicator, Integral mounting bracket.
Blocked end design,
Fully serviceable,
Rated to 225 PSI,
Integrally molded
stem support &
mounting platform,Full port, All plastic construction, Double “O”- ring stem seals, Adjustable seats
Needle Valves are
used for accurate
metering of fluids.
Turning the valve
handwheel moves
a tapered plastic
piston into a Teflon seat to control flow
from full open down to drops
Hayward all-plastic
diaphragm valves
are used for on/off
and modulating
control of liquids,
gasses, and vacuums,
and are suitable for both clean
and slurry-type fluids at pressures up
150 psi rated valve,
Fully supported
flange bolt holes
that prevent
stressing of
mating
pipe flanges, V-Notch retention design liner provides positive sealing of
liner to the valve body
Hayward Plastic
“True Check” Ball
Check Valves
prevent reversal of
flow in piping
systems. They are ideal where backflow could potentially cause damage to pumps.
